Preparing and Sending Dynamic Messages

You can set content and parameters of Dynamic Messages as necessary to send a specific message to a receiver device.
Proceed as follows:

  1. In System Browser, in [OPC SORIS Network] > [OAP Adapter] > [OAP Server] > Dynamic Messages, select the dynamic message node you want to prepare and send out.
  2. In Extended Operations, configure the following:
    • Subject Text
    • Body Text
    • Beep Code (Range: 0-99; Default value: 2; 10-99 reserved)
    • Priority (Range: 1-9, lower values correspond to higher priority; Default value: 6;
      1: alarm priority (use with special care); 2-4: high priority; 5-7: normal priority; 8-9: low priority)
  3. Enter the Receiver Device ID and select Send.