Create the Event Commands Macros

  1. In System Browser, select the Manual navigation check box to retain the Macro tab.
  1. Drag the target scope object (in this case, ID3000 Network Scope) from System Browser to the empty area inside the Macro tab.
  • A new row is created.
  1. Configure the other fields as follows:
  • Property: Alarm Status [Alarm]
  • Command: Ack [Ack]
  1. Click Save As .
  1. In the Save Object As dialog box, enter the following name and description:
  • BLOCK_ACK_ManagementView_FieldNetworks_[ID3000NetworkName]
  1. Click OK.
  • The new macro is added to System Browser under the specified macros folder.
  1. Start from the ACK command macro, and in the Commands column, select the Reset command.
  1. Click Save As .
  1. In the Save Object As dialog box, enter the following name and description:
  • BLOCK_RESET_ManagementView_FieldNetworks_[ID3000NetworkName]
  1. Click OK.
  • The new macro is added to System Browser under the specified macros folder.

Abiding by naming conventions is essential

Since the name of the macro is strictly connected to the name of the network in the specific project, this action must be performed after the creation of the network itself, and must be performed manually, project by project.
Abiding by the above-mentioned naming convention is mandatory for the event commands to work for zone, detectors, and modules events.